Stamping die is a necessary process technology for stamping, and it is of great significance in stamping production. When the stamping die is off the machine, the operator's operating procedures are shown in the following 6 points, which must be kept in mind and operated to prevent damage to the die.

1. Before opening the stamping die, make sure that the tape support plate at the feed port of the die has been loosened and obtained.

2. When the mold cannot be pulled, one person can pull it out and one person push it back. It can also be screwed on the wire hole of the lower die base with the lifting screw, and then lift it up a little with both hands at the same time and then drag it out.

3. When the die is pulled away from the punch, the die car cannot be turned too fast, so as to avoid the guide plate or material support plate on the punch or the soundproof cover of the punch, causing damage to the die parts or The mold slipped off.

4. When the mold drops abnormally, the operation cannot be started again, especially after the plastic of the mold stopper.

5. After the die is lowered, turn off the punching machine and other power supplies to prevent wasting resources.

6. After the mold stops normally, move the mold slowly to run until the guide pin enters the round hole of the material belt. It is strictly forbidden to stop the die at the bottom dead center, which will easily reduce the service life of the torsion spring in die stamping.